Advice available on minimising canola losses
Author: Natalie Lee | Date: 07 Oct 2019
Some canola growers reported boosting their profits by more than $50,000 in 2018 simply by regularly adjusting harvester settings after measuring canola losses from the back of their harvesters.
A new Grains Research and Development Corporation (GRDC) fact sheet outlines the experiences of these growers and contains information about how to improve profits by setting up harvesters correctly, in order to minimise canola falling to the ground.
Planfarm consultant Peter Newman led a GRDC project last harvest aimed at addressing the issue of canola losses from the rear of harvesters and results from his work are contained in this publication.
“An estimated $191 million of canola is lost in this way nationally every year – based on average losses of 150 kilograms per hectare or $75/ha across approximately 2.5 million hectares of this high value crop grown across Australia every year,” he said.
“This estimate is based on measurements made by Western Australian canola growers and is consistent with what has been found in western Canada where canola harvest losses have been measured extensively.
“WA growers involved with the canola losses project were unaware they were losing grain until they measured actual losses using commercially available drop trays,” he said.
“They were then encouraged to adjust their harvester settings and share their findings and dollars saved using the Twitter handle @harvestloss.”
Mr Newman said one setting at a time should be changed and actual losses measured again after each adjustment to assess impact.
“Harvester settings that influence canola lost include the rotor speed, the gap between the rotor and the concave (separator), the cleaning fan speed, the openings of the upper sieve and the openings of the lower sieve,” he said.
“It’s advisable to measure actual canola losses once or twice a day during harvest, given changing conditions, and to involve the harvester drivers who can pride themselves on aiming to hit the ‘sweet spot’.
Mr Newman said all harvesters were capable of achieving minimal losses with the right set up and settings, and the aim was not to produce the lowest losses per hectare, but the lowest cost of harvesting per tonne of grain.
“The ideal is to find the optimum point at which harvest efficiency is high and losses are low – the sweet spot,” he said.
The project focussed on canola losses from the rear of the harvester and did not consider front losses.
Meanwhile, the Department of Primary Industries and Regional Development website contains up-to-date information about maximising the amount of grain heads (or pods) entering the harvester when harvesting short, patchy crops.
The information states that significant harvest losses can occur at the header front, particularly in dry years, if heads or pods are mechanically dislodged from plants-by knives, cutterbar and reels – before entering the front, and contains tips to help WA growers in dry seasons.
Peter Newman, Planfarm
08 9964 1170, 0427 984 010
Natalie Lee, GRDC
0427 189 827
GRDC Project code: PLN1803-001SAX
Was this page helpful?